Skip to content
Cut List Ledger

How Saw Kerf Changes a Cut Plan

Spacing between parts uses a saw cut. Trim accounts for the outer edge of the sheet.

Saw kerf is the width removed by a cut

A blade removes a strip of material. In a layout that places two pieces next to each other, their finished widths need room for that strip between them. A tool with a wider kerf needs more material for the same cuts.

Use the width that applies to your blade and setup. The blade's listed kerf can be a starting point. If your project demands a tighter fit, check the value using a suitable piece of scrap and your normal setup.

Put finished sizes in the parts list

Consider a usable sheet that is 10 inches wide. Two pieces 5 inches wide exactly fill it when the kerf is zero. At a 1/8 inch kerf, two 5 inch pieces next to each other would require 10 1/8 inches. Increasing the sheet width or changing the plan can make both pieces fit.

Leave each planned piece at its finished width in the input. The calculator already reserves the kerf gap when it makes an adjacent placement. Adding kerf to every finished part dimension would reserve more space than intended.

Keep edge trim separate

Edge trim reserves an even border on all four sides of every sheet. A 48 inch width with 1/8 inch trim on both outer width edges leaves 47 3/4 inches of usable width. Kerf still applies between the cuts inside that smaller rectangle.

If you measured the stock after squaring the edges, use those measured dimensions and leave edge trim at zero unless you want another allowance. Try the numbers in the cut list calculator to see how the margin and kerf change the layout.