Skip to content
Cut List Ledger

How to Plan Plywood Sheet Cuts

Build one cut list for each job and check it against the sheets you can actually use.

Measure what you can cut

Start with the stock you have on hand. Tape measures rarely agree with a nominal product name on every sheet. Record the usable rectangle. If the edges need trimming, decide whether your measurements already account for that trim. A piece that must finish 24 inches wide should be entered as 24 inches, with the saw kerf entered separately.

Use different material labels for different thicknesses or finishes. For example, label 3/4 inch birch and 1/4 inch backer separately. A part line with the backer label will only use your backer stock.

Decide how the grain should run

When the sheet grain runs along its length, enter a grain-sensitive part so its length follows the same direction. Lock orientation on that part. An unlocked square may look the same in the drawing even if its finish has a direction, so lock any part that needs consistent alignment.

A rectangular door often needs a different orientation from a cabinet back. Keep those part names apart even when the rectangles happen to be the same size.

Start with the larger panels

Make sure every large side, top, and back fits a matching sheet after trim. Then check the smaller shelves or rails. If large parts use up your stock, check whether a measured remnant can hold the smaller pieces. Add an offcut as its own stock row using the measured dimensions and existing grain direction.

Try the cabinet example, then reduce the stock count to see the unplaced list. A missing part does not always mean the part is larger than the sheet. It might fit when a second sheet is available.

Read the job packet before cutting

The printed summary lists available and used sheets. Every sheet drawing marks the pieces with labels. On screen, you can open the positions in the table below each drawing. The CSV gives you the same coordinates in a format you can sort or filter by material or label.

The diagram is a layout, so work out the sequence and orientation of physical cuts separately. Use the stock you measured and check the finished size of the first piece before cutting copies. If any dimension changes, recalculate and print a new plan. See the saw kerf guide for how the measurement is applied.

For long stock that only needs crosscuts, use the lumber cut list guide.