How to Plan a Lumber Cut List
Compare suitable board lengths, check the saw allowance, and count the boards you will use.
Use the actual stock width and length
Measure the board you plan to cut. For a common 2 by 4, enter its measured width, which may be 3 1/2 inches rather than the nominal number in its name. If all parts use that width, give them the same width in the parts list. Enter each finished part length once and use the quantity field for copies.
Use different material labels for boards that differ in species, finish, or thickness. You can list different lengths of the same material in separate stock rows.
See what one saw cut changes
In the calculator, select Load lumber example. It has two boards that are 3 1/2 inches wide and 96 inches long. It needs two 48 inch parts of the same width with rotation locked.
At a 1/8 inch saw kerf, the two parts use two boards. They need 96 1/8 inches when placed on a single board. Change the available stock quantity to one and calculate again. The missing part appears in the unplaced section and in the CSV. Changing the kerf to zero shows why the finished lengths alone appear to fit.
Compare your options
- Use another board. Add its measured size and check the stock count and remaining pieces.
- Use longer stock. Enter the actual longer length and compare the used and unused quantities.
- Add a remnant. Measure the part of the remnant that is straight and usable. Give it the same material name when it can replace the full board.
For end-only trim, enter the usable length after reserving material at the ends. The calculator's trim input reserves the same space on every edge, including the long sides, so leave it at zero when the given dimensions already reflect that allowance.
Print a reference for the job
The material summary tells you how many stock pieces the plan uses. Every drawing shows the length across the page. The CSV gives you the coordinate and finished size of each part. Check the board and part sizes and work out the physical cut sequence with your own equipment before using the plan.
For the difference between edge trim and saw kerf, see the saw kerf guide.